TurboCrimper® IMPACT

Get the competitive edge with a labor and cost saving TurboCrimper® Impact driver attachment. Based on actual field trials, the TurboCrimper Impact is 78% faster than using a manual sheet metal crimping tool!

This sheet metal crimping attachment is designed to work with a minimum 12 volt DC cordless or maximum 7 amp AC corded IMPACT DRIVER. No set up or adjustment is needed. Immediately begin crimping multiple sizes, types, and thicknesses of round metal duct (Including spiral duct and metal stove pipe). It’s also easy to balance while using and stores comfortably in a pouch or bag when not in use.

Attention: Use Impact Driver Only! Minimum 12V DC Impact Driver With Quick Release 1/4 in. Hex Chuck.

Check out our product spotlight for the TurboCrimper Impact, Sheet Metal Crimping Tool by clicking the link below:

Tool Barn’s Barn Banter



  • The TurboCrimper Impact is 5 times faster than a manual sheet metal crimper.
  • Saves time and labor on your next job.
  • No setup or adjustment is needed, just chuck up and go.
  • Easily stored in a bag or pouch when not in use.


Capacities: Ga (mm)

Galvanized Steel 30 – 24 Gauge Cold Rolled Steel 30 – 24 Gauge
.016 – .034 (0.41 – 0.71) .016 – .034 (0.31 – 0.61)




My Review for TurboCrimper® IMPACT

  • This field is for validation purposes and should be left unchanged.